Archive for the ‘nmcli’ Category
Waking up the Network
Interesting problems seem to plague me from time to time. The current problem isn’t yet solved but I’m working on it. After a sleep cycle, IPV6 networking isn’t starting.
Try:
- Checking the network cables, modem, and router
- Reconnecting to Wi-Fi
ERR_INTERNET_DISCONNECTED |
In the broken Fedora 30 VM, I checked the status with the nmcli tool:
sudo nmcli general status |
It returned:
STATE CONNECTIVITY WIFI-HW WIFI WWAN-HW WWAN asleep none enabled enabled enabled enabled |
The STATE should return connected and connectivity return full. Unfortunately, that’s not the case.
There was little surprise that the next check:
sudo nmcli device |
Returned the following:
DEVICE TYPE STATE CONNECTION virbr0 bridge unmanaged -- ens33 ethernet unmanaged -- lo loopback unmanaged -- virbr0-nic tun unmanaged -- |
In a working instance, it should return:
DEVICE TYPE STATE CONNECTION ens33 ethernet connected ens33 virbr0 bridge connected virbr0 lo loopback unmanaged -- virbr0-nic tun unmanaged -- |
I’m currently troubleshooting what failed by leveraging an article on How to Configure Network Connection Using ‘nmcli’ Tool and the Gnome nmcli documentation. Naturally, when I get it fixed, I’ll finish this article.